Signup for trailside coupons!

Get trike coupons, news & fun event invites.

View our privacy policy and terms

We're open until 4:00p EST. Closed on Sun. & Mon.

T-Cycle Custom Arkel Bag Mount

$40.00
Move your Arkel bag closer for easier access by replacing the stock mounts with these from TerraCycle.
1 in stock
Delivery time: 1-2 business days

We adore the Arkel packs, however the decent mounting clips that accompany them are intended for upstanding bicycle handlebars, so they expand the bag out too far from reach on a trike. When you use bags next to your seat, it's pleasant to have them right up front, to make them simpler to reach and to keep the pack inside your wheel profile. These clips carry your pack as near the mounting tube on your TerraCycle SeatSide Mount as could be expected under the circumstances, so you can modify the bag to where you truly need it. An extraordinary method to make a great Arkel pack...perfect for the trike rider.  Note that these braces are estimated for our SeatSide Mount framework, which uses 7/8" (22.2mm) tubes.

 

ADDITIONAL INFO

  • They replace the stock Arkel clamps, allowing you to move your bag about 2.5 inches (6cm) closer to you. This is usually enough to get the outside of the bag even with the outside of your front wheel, or even closer. Very nice for getting through narrow spaces, and for making the bag even easier to reach into while riding.
  • CNC Machined aluminum, clear anodized. Spec'd to match the stock Arkel mounting clamps, except that they are as close in as possible and mount natively to a 7/8 in (22.2mm) tube (no shims required).
  • Since they are native 7/8in clamps, this means they slip on and work perfectly with the T-Cycle SeatSide Mount system, but won't worh with the ICE side of seat mount, because the ICE mount is 1 inch.
  • Anodized aluminum with stainless m5 mounting bolts. Clamps to a 7/8in (22.2mm) round tube.
  • Slide clamps on mounting tube. Clip Arkel bag onto clamps to set the correct width between the clamps. Adjust the up/down angle of the bag and tighten one of the clamps. Carefully align the second clamp to make sure it is parallel to the first clamp, then tighten it also. Check that the bag can be easily removed and reinstalled. Double check the alignment of the two clamps by sighting along the arm of the SeatSide Mount to ensure both clamps are parallel to each other. Lay something flat against the back of the clamps if you are not sure. It should be easy to remove and install the bag if the clamps are parallel and the right distance apart.
  • Fits on any mount that uses 7/8" (22.2mm) tubes.
0 stars based on 0 reviews
Customer Service
Customer Service
Packed with care
Have questions? Chat with an expert now